“1/16 South Dixie Charger”
Here is a few body lines being added. These are what
makes the 1968-70 Dodge Chargers what they are.
Now for the big part of the build. Correcting those
open wheel wells on the front fenders. First a body line
has to be found. Then backing must be added inside the
fender well. Masking tape is used for this. A correct
arc is found.
Now the Arc was found, we made a temp with the making tape
once that was done we cut that out. Now here you can see
the pieces have been made and cut out.
Now the pieces was glued into place and filled. Sanding was
done to smooth it out
Here is the process after smoothing to light coat of primer
to a coat of gray primer. Now we have a correct arc
wheel well.
Now as we move onto the driver side door. We need to fix that
molded in and on door handle. Time to carefully remove it
and correct it!
Another light coat of primer was sprayed
Now we move onto the front end and pass side.
We still need to correct these areas yet. So lets start!
Now we super glued the front valance panel into place here
because we really need to work on this piece and correct it
and add a lot more detail to it.
